NEUSPEED Power Module For 1.8T & 2.0T

 

Brand Description:

 

USP Motorsports is proud to offer Neuspeed products, the number one source for aftermarket import performance products! Offering the highest quality performance parts and wheels for your vehicle, designed, engineered, and manufactured with a special pride no longer seen, Neuspeed are committed to offer the best products available.

 

Product Description:

 

NEUSPEED Power Module is a device which easily allows most able person to upgrade the performance of their 1.8/2.0 TSI (Gen3 engine) without reducing the reliability or integrity of the engine, clutch and driveline. This is the simplest and best alternative or option to chip tuning. The NEUSPEED Power Module is an all new design, not some rebranded 3rd party product. It is a plug and play box that intercepts at the MAP and Boost sensors and can be installed or removed within minutes without any detection. There is a convenient two position switch for 91+ premium fuel and 100+ octane race fuel for maximum HP output. The electrical components are housed in a billet aluminum enclosure which is protected from the elements and is designed and manufactured to be positioned within the engine bay of your vehicle. The wire harness is manufactured using automotive quality wiring which is both oil and heat resistant, and has the same OE water proof connectors as used on your engine.

 

NEUSPEED Power Module's are designed, engineered and tuned for a specific engine, not a generic box.

 

NOTE: The USA delivered GTI is under rated from the factory, our dyno shows about 225HP with the boost spiking at 1.3 bar (19 psi) in stock form, so raising the boost to spin the factory turbo to it's peak efficiency whether ECU tuned or Power Module will yield about 260HP in stock engine configuration using 91 octane fuel. Dyno sheet is available for viewing, the vehicle had no other modifications and was running on 91 pump gas for a fair test comparison. The chart shows Stock, Power Module +5 and Power Module +7 runs.

 

Features:

 

Two position switch:

 

+5 PSI Increase

+7 PSI Increase

Power / Torque Gain - 91 Octane Fuel (higher gains obtainable with better octane fuel) :

 

1.8 TSI: 30+ HP /  55+ ft./lbs.Torque

2.0 TSI: 35+ HP /  70+ ft/lbs.Torque

2.0 TSI "Budack/Miller Cycle": 30+ HP /  55+ ft./lbs.Torque

Increases boost by modifying the charge pressure and map sensor readings

 

Allows ECU to remain in control of boost

The actual boost is increased by a precise amount

Boost is increased in a gradual, progressive fashion

Uses the closed loop control of the ECU to increase boost

 

Readings in the vacuum region are stock

No effect on cold start

No effect on warm-up

No change to idle, cruise and moderate acceleration modes of operation

 

Retains stock ECU programming

No change to factory ECU programming, communication or safety protocols

No ECU TD1 code to void manufactures warranty

Not effected by ECU reprogramming by the dealer

Makes use of existing ECU programming for higher boost levels

Correct Air/Fuel mixture maintained from the wide band O2 and closed loop mode of the ECU

Ignition timing optimized by the ECU

 

Easy Installation

Plug-and-play intercept at Boost and MAP sensor connector locations

Installation or removal can be completed in a few minutes (depending on model)

No trace Power Module was ever there after removal

Power Module can be sold or installed on another vehicle of the same engine type.

Notes:

 

Fits: 2014-up Audi A3/S3 (8V) 1.8 TSI/2.0 TSI and 2015-up VW MK7 GTI including Performance Package, Golf R and Golf 1.8 TSI.

 

NOTE: NEUSPEED POWER MODULE WORKS ON ALL ECU BUILT BEFORE AND AFTER MARCH/APRIL INCLUDING 2016.

 

CARB Pending. Emission testing to be California compliant and any states that follow.

 

Designed and Engineered Camarillo, California. Made in USA

 

NOTE: NEUSPEED P-FLO Air Intake highly recommended.

 

DO NOT USE POWER MODULE IF ECU HAS BEEN TUNED OR MODIFIED.