P3 Integrated Digital Vent Gauge V3 OBD2 For BMW E9x 3 Series 08+ (Pre-Installed Vent)

The P3 V3 allows you to connect to your car in an entirely new way. The V3 is more than just a gauge, capable of displaying dozens of engine parameters the V3 is the first and last gauge you will ever need. In addition to displaying engine parameters, the V3 is capable of recording 0-60mph times. P3 understands that a gauge can be difficult to read under racing conditions especially when trying to keep control of your vehicle. For that reason the V3 features peak recall to show the peak value of any parameter as well as a 15 second playback.

Have a check engine light? The V3 is capable of reading fault codes as well as clearing a check engine light. All units of measure can easily be adjusted from U.S. (PSI, Fahrenheit, MPH) to metric (Bar, Celsius, KPH). The V3 can also display values from external 0-5 volt sensors including air ride suspension pressure and many others.

This V3 kit features a plug and play installation that can be completed in approximately 30 minutes. Simply follow the instructions and easily install the V3 display in your car's existing vent housing. Once the display is installed simply plug in the included cable to your car's OBD-2 port located near the driver's feet and you're done.

The optional analog boost sensor allows your V3 to more precisely measure vacuum and boost up to 80psi. This is needed for modified vehicles which are exceeding the measurable range of the factory boost pressure sensor.

The V3 displays the following parameters:

• Boost/Vacuum
• Coolant temperature
• Intake air temperature
• Throttle angle
• Ignition timing
• Engine RPM
• Exhaust gas temperature
• Speed
• Battery voltage
• Acceleration timers (0-60mph/0-100mph/60-130mph)
• Braking timers (60-0mph/100-0mph)
• Analog input 1 (brown wire) can allow gauge to read any 0-5 volt linear output sensor
• Analog input 2 (blue wire) can allow gauge to read any 0-5 volt linear output sensor